Design And Installation Safety - Epson G10 Series Manual

Setup & Operation 1. Safety

1.2 Design and Installation Safety

Only trained personnel should design and install the robot system.
personnel are defined as those who have taken robot system training and
maintenance training classes held by the manufacturer, dealer, or local
representative company, or those who understand the manuals thoroughly and
have the same knowledge and skill level as those who have completed the training
courses.
To ensure safety, a safeguard must be installed for the robot system. For details
on the safeguard, refer to the Installation and Design Precautions in the Safety
chapter of the EPSON RC+ User's Guide.
The following items are safety precautions for design personnel:
■ Personnel who design and/or construct the robot system with this product must
read the Safety chapter in the EPSON RC+ User's Guide to understand the
safety requirements before designing and/or constructing the robot system.
Designing and/or constructing the robot system without understanding the safety
requirements is extremely hazardous, may result in serious bodily injury and/or
severe equipment damage to the robot system, and may cause serious safety
problems.
■ The Manipulator and the Controller must be used within the environmental
conditions described in their respective manuals.
designed and manufactured strictly for use in a normal indoor environment.
WARNING
Using the product in an environment that exceeds the specified environmental
conditions may not only shorten the life cycle of the product but may also cause
serious safety problems.
■ The robot system must be used within the installation requirements described in
the manuals. Using the robot system outside of the installation requirements
may not only shorten the life cycle of the product but also cause serious safety
problems.
Further precautions for installation are mentioned in the chapter Setup &
Operation: 3. Environments and Installation. Please read this chapter carefully to
understand safe installation procedures before installing the robots and robotic
equipment.
4
Trained
This product has been
G10 / G20 Rev.2