Editing A Failover Package - HP StorageWorks 8000 - NAS User Manual

Editing a Failover Package

Note:
Before you proceed, you must stop the failover package to edit the information.
To edit a failover package:
1. In Command View NAS, click the Storage tab.
2. Navigate to Failover Packages.
3. Select Actions > Edit Selected Package.
4. Select a Failback Policy from the drop-down list.
5. Check Auto Start if you want the failover package to automatically start once
6. Check Reboot Node on Failure if you want the server to automatically reboot
7. Select a Primary Node from the drop-down list.
8. From the Available Volume Groups list, select the volume group you want to
9. Enter a Virtual IP Address (an IP address used to access the storage
10. Click OK. To activate the failover package, you must start it. See
Applies to high-availability NAS solutions only.
the server is running in the cluster.
if a failure occurs.
include in the failover package, then click Select.
associated with the failover package) and enter the Subnet. Click Add.
Failover Package on page 112 for information.
Managing Your Storage
Starting a
111