Configuring Veritas Netbackup For Use With Ndmp - HP StorageWorks 8000 - NAS User Manual

6. Enter the device file name of the tape changer. Remember to use the lettered
7. Select option 2 for the NDMP type of the NAS server.
See the software documentation for NetWorker for details about completing
jbconfig setup, and for instructions on setting up NDMP for NetWorker.

Configuring Veritas NetBackup for use with NDMP

Note:
NDMP Version 3. These versions of NetBackup do not support Direct Access Recovery
(DAR) at this time.
1. Install NetBackup as described in the NetBackup software documentation.
2. Install NDMP for NetBackup.
3. Open a command line on the NetBackup server. From the install path, execute
4. Enter a password, using the same one that is used for NDMP.
5. Enter the password again as confirmation.
6. For three-way backups, enter the following for the NAS server that has no
7. Enter a password, using the same one that is used for NDMP for this NAS
8. Enter the password again as confirmation.
9. If you want to configure a robotic changer, you need to supply the:
device file, found in the Backup Device section of the NAS 8000 user
interface.
Use NetBackup 3.4/3.4.1 with NDMP Version 2; use NetBackup 4.5 with
set_ndmp_attr -auth NAShostname root
storage device:
set_ndmp_attr -auth NAShostname root
Server.
— lettered device file for the changer
— controller number
— SCSI ID
— LUN
For example:
set_ndmp_attr -robot NAShostname /dev/sga 3 0 3
Configuring Your System and Network
95