HP StorageWorks 8000 - NAS User Manual page 64

Configuring Your System and Network
If you have DHCP enabled, primary NIC configuration occurs automatically.
In addition to the primary NIC, which is used exclusively by the iLO, each NAS
Server has a dual-channel 10/100 card installed in a PCI slot. The card can expand
to allow for an additional port; thus you can have two ports per NAS Server.
Depending on your configuration, the DHCP server provides any or all of the
following parameters: IP Address, Subnet Mask, Gateway Address, Broadcast
Address, and DNS Domain Name.
To edit the IP configuration for a NIC port:
1. In Command View NAS, click the Configuration tab.
2. Under TCP/IP, select IP Addresses. A table lists:
3. Select the Port you want to edit, then select Actions > Edit Selected IP
4. Select an address configuration (manual or DHCP) from the drop-down list.
5. Click OK.
64
— NIC Ports and configured bond channels (if a bond channel is not
configured, it will not appear in the table)
— Address configuration (whether it is manual, DHCP or bonded to a bond
channel)
— IP Address
— Gateway Address
— Subnet Mask
— Broadcast Address
— Management Port (indicated by yes or no)
— MAC Address
— Card speed
Configuration.
For a manual configuration, enter the IP Address, Gateway Address, Subnet
Mask, and Broadcast Address.