Using Emp Monitor - Epson PowerLite 7900p User Manual

To change the network addresses from the projector's control
■
panel, press the right and left arrow buttons to select the part
of the address you want to enter, then use the up and down
arrow buttons to increase or decrease the numeric value.
Select the
part of the
address to
change
When you finish changing an address in the network menu, press
the button (on the remote control) or the
Enter
button (on the projector). This stores the value.
6. When done making all necessary changes, press
menu system.

Using EMP Monitor

EMP Monitor lets you manage all your projectors using a remote
computer. This lets you easily turn the projectors on or off (together
or individually), switch image sources, and check on their status.
Before using EMP Monitor, make sure you've installed the software as
described on page 86. The computer you're using to monitor the
projector should already be connected to your network.
Increase
or
decrease
the value
Auto/Enter
to exit the
ESC
Managing the Projector from a Remote Computer
89