Adjusting Color Corrections For A New Surface; Shutting Down The Projector - Epson PowerLite 7900p User Manual

Adjusting Color Corrections for a New Surface

Adjust the correction values if you're projecting on a new surface or in
a new location.
1. Press the
Wall Shot
while you're projecting an image. Wait for the Wall Shot status
screen.
2. Press the
Wall Shot
on the status screen.
Readjustment
You see a sequence of colors flash for about five seconds as the
projector adjusts the color correction values for the new
projection surface.

Shutting Down the Projector

When you've finished using the projector, follow the recommended
procedure to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.
1. Turn off and disconnect any equipment plugged into the
projector.
2. To turn off the projector, press the red P
projector or remote control.
You see a confirmation message. (If you don't want to turn it off,
press any other button.)
button on the remote control or projector
button until you see
Wall Shot
Power
note
When the projector has not
received any input signals
for 30 minutes, it
automatically turns off the
projector lamp and enters
"sleep mode." This conserves
electricity, cools the
projector, and extends the
button on the
life of the lamp. If you want
to start projecting again,
press the P
If you are done using the
projector, unplug the power
Power button
cord. To turn off sleep mode,
see page 76.
Turn off this product when
not in use to prolong the life
of the projector.
Power OFF? Power OFF?
Yes : : Press Yes
No : : Press any other button No
button.
Power
Press button button
Press any other button
Projecting
49