Epson PowerLite 7900p User Manual page 98

note
The projector must be
plugged in (projecting or in
standby mode) for you to be
able to connect to it.
To access a projector in
standby mode, you must
select as the
Network ON
setting in
Standby Mode
the projector's menu system
(see page 75).
Remember that when
Standby Mode is set to
, the exhaust
Network ON
fan continues to operate
after the projector has cooled
down. This is normal.
Managing the Projector from a Remote Computer
98
3. EMP NetworkManager connects to the projector, and you see
this screen:
4. Verify that the network settings are correct. (If DHCP is on, you
don't need to verify network settings.)
■ Make any desired changes to the projector's network address
configuration (turning off DHCP enables the manual
settings).
You can give the projector a name—up to 15 characters long,
■
including the following symbols:
Naming the projector helps you identify it in EMP Monitor
and EMP NetworkManager, especially if you're managing
more than a few of them.
5. Click
Mail Notification Settings
You see this screen:
! @ # $ % ^ & ' . - _ { } ~
.