Turning On Password Protect And User's Logo Protect - Epson PowerLite 7900p User Manual

The password will be displayed as
digit, a confirmation screen appears. Enter the password again.
5. After you finish setting the password, press the
return to the Password Protect menu.
6. Press the button on the remote control to turn off the
Num
numeric keypad.
Make a note of the password and keep it in a safe place in case you
forget it.
Turning On Password Protect and User's Logo
Protect
1. To enable the password, press the
control for about 5 seconds until you see the Password Protect
menu.
2. Select
Power ON Protect
3. Select and press
ON
4. If you want to disable the password temporarily, select
press . Then hold down the
Enter
numeric keypad to enter the number of hours (from 0 to 9999)
that you want the password feature disabled. If you want the
projector to request the password every time it is turned on, set
the timer to . Press
0H
The countdown for the elapsed time begins as soon as you close
the Password Protect menu. (You can check the elapsed time in
this menu next to
5. To turn User's Logo Protect on, select
press . Select
Enter
When this feature is on the logo appears whenever the projector is
turned on (if the
No-Signal Msg.
menu; see page 80) and as the A/V Mute screen (if you selected
the as the
Logo A/V Mute
the User's Logo features can be changed when the User's Logo
Protect function is enabled.
. After you enter the last
****
Freeze
and press
Enter
. Then press
Enter Esc
button while you use the
Num
when you're done.
Enter
.)
Time elapsed
User's Logo Protect
and press .
ON Enter
is set to
setting in the Setting menu). None of
button to
Esc
button on the remote
.
.
and
Timer
and
on the Setting
Logo
note
If you make a mistake
entering the time, press the
button and enter the
Esc
time again.
Fine-tuning the Projector
81