Epson 7900p - PowerLite XGA LCD Projector Lens Installation
Supplemental / late breaking information
Hide thumbs
Also See for 7900p - PowerLite XGA LCD Projector:
- User manual (146 pages) ,
- Product information (24 pages) ,
- Product support bulletin (7 pages)
Related Manuals for Epson 7900p - PowerLite XGA LCD Projector
Summary of Contents for Epson 7900p - PowerLite XGA LCD Projector
-
Page 1: Lens Installation
EPSON ® Lens Installation Installing an optional lens in the no-lens model of your PowerLite projector ® CPD-18790... - Page 2 Follow these instructions to install an optional lens in the no-lens model of your projector. Warning: To avoid electric shock, disconnect the power cord before starting. 1. Remove the protective seal from the projector. 2. Turn the projector over and use a screwdriver to remove the lens cover. 3.
- Page 3 4. Remove the front and rear caps from the new lens. 5. Lower the lens into the projector, making sure the focus and zoom knobs face downward so they fit through the slot in the projector’s case. Caution: Make sure to support the front of the lens and keep it level, or you could damage the guide pins.
- Page 4 7. Replace the lens cover and tighten its screw. 8. Turn on the projector and verify that it operates normally. Epson is a registered trademark of Seiko Epson Corporation. PowerLite is a registered trademark of Epson America, Inc. © 2004 Epson America, Inc. 8/04...
- Page 5 Before you start using the projector, turn it over and attach the lens cover as shown: Epson is a registered trademark of Seiko Epson Corporation. PowerLite is a registered trademark of Epson America, Inc. © 2004 Epson America, Inc. 8/04...