Communication Setup Options - Epson PowerLite 7900p User Manual

■
Progressive (in the Advanced1 menu)
This setting should normally be left at its default setting (
or ). Converts interlaced signals to progressive signals.
Film/Auto
When set to , interlaced signals are processed without
OFF
conversion (available for video signals only).
■
BNC Sync Termination (in the Advanced2 menu)
This setting should normally be left
analog (75-ohm) terminator is required, as for a switcher, change
the setting to .
ON

Communication Setup Options

These options let you set up the projector so it can be monitored and
controlled from a remote computer (see Chapter 5).
■
Standby Mode (in the Advanced1 menu)
Select
Network ON
a network when it's in standby mode; this setting also lets you
view images on an external monitor during standby, if the
monitor has been connected to the projector's
■ Network (in the Advanced2 menu)
Used for managing the projector over a network (see Chapter 5).
If the network assigns addresses automatically, turn on
Otherwise, turn off
, and
Subnet Mask
If you want to monitor the projector using a network
management utility, select
address.
■
COM Port (in the Advanced2 menu)
Used for communicating with a computer running the EMP
Link21L utility software. (You can download this utility free of
charge from http://support.epson.com.) Select
depending on the port that's being used for communication with
the computer. Turn off the projector and then turn it back on for
the new setting to take effect.
(for TTL input). If an
Off
to enable the projector to be monitored over
and enter the projector's
DHCP
, if applicable.
Gateway Address
and enter at least one trap IP
SNMP
Video
port.
Monitor Out
.
DHCP
,
IP Address
or ,
RS-232C USB
Fine-tuning the Projector
note
Press the button on
Num
the remote control to use the
number keypad.
Zero
Num
button
75