Monitoring Projector Errors With Emp Monitor And Snmp - Epson EasyMP EMP-735 Setup Manual

Functions
Connecting Via an Access Point in a Wireless LAN
If a wireless LAN system is already installed in an office, use the "Access point
mode" to share projectors from a participating computer via the company network.

Monitoring Projector Errors with EMP Monitor and SNMP

Using the "EMP Monitor" provided on the included CD-ROM, it is possible to
simultaneously monitor and control the projector from a computer, when using
"Access point mode" to connect to a computer on a wireless LAN. The monitoring
function monitors the error state, power status, and input status of the projector. The
control function performs simultaneous start-up, and image signal input switching
of multiple projectors. Using EMP monitor, it is possible for a single operator to
control the simultaneous starting and monitoring of projectors arranged in separate
classrooms or meeting rooms.
You can also use SNMP
computer. SNMP creates a notification message when an abnormal condition occurs
on a projector, and sends the notification to a computer identified by a pre-defined
IP address.
* In order to monitor a projector using SNMP, you need to first install SNMP
management software on the computer.
6
to monitor and control the status of projectors from a