Subnet Mask - Epson PowerLite 7900p User Manual

note
If you're a network
administrator, you can use
the option to enter a
SNMP
trap IP address. This lets you
receive trap alerts for the
projectors you're monitoring.
If you have HP OpenView,
a plug-in will be available
to allow you to manage your
projectors in HP OpenView.
Check with your dealer or
Epson for availability (see
page 121).
Managing the Projector from a Remote Computer
88
3. Press the button on the remote control and select
Menu
from the
Advanced2
Video Video
Brightness Control Brightness Control
Audio Audio
Projector ID Projector ID
Effect Effect
Network Network
Setting Setting COM Port COM Port
User's Logo User's Logo Auto setup Auto setup
Advanced1 Advanced1
BNC Sync Termination BNC Sync Termination
Advanced2 Advanced2 Reset Reset
About About
Reset All Reset All
[ [ ]: Select ]: Select [ [ ]: Enter ]: Enter
4. If your network assigns addresses automatically, turn on
5. If your network does not assign addresses automatically, turn off
and enter the projector's
DHCP
Gateway Address
To enter numbers using the remote control, press the
■
button until it lights, then use the number keypad shown
below.
Num button
menu.
:
High High Low Low
: 1 : 1
Set Set
Set Set
: RS-232C RS-232C USB USB
:
ON ON OFF OFF
:
ON OFF ON OFF
Execute Execute
[Menu]: Exit [Menu]: Exit
IP Address
, and , as needed.
MAC Address
Zero
Network
Select Network
.
DHCP
, ,

Subnet Mask

Num