Intergraph InterRAID-8e Hardware User's Manual page 66

52
Option
Rebuild Rate
Alarm Control
Auto Rebuild
Logical Drive
Choose the Logical Drive option from the Objects menu to select a logical drive and to
perform the listed actions.
The following table describes the Logical Drives options.
Option
Initialize
Check
Consistency
View/Update
Parameters
Description
Choose this option to change the rebuild rate for the controller. You can
also display the firmware version number.
Choose this option to enable, disable, or silence the onboard alarm tone
generator. Default is disable.
Choose this option to enable automatic rebuild. Default is enabled.
Description
Choose this option to initialize the selected logical drive. This should be
done for every logical drive you configure.
Choose this option to verify the correctness of the redundancy data in the
selected logical drive. This option is only available if RAID level 1, 3, or
5 is used.
Choose this option to display the properties of the selected logical drive;
you can modify the cache write policy, read policy, I/O policy, and
FlexRAID Virtual Sizing from this menu.