Connected Targets Tab - HP StorageWorks MPX200 User Manual

5. Select the Connected Targets tab, and then click the Toggle Start-Up button for each target listed
so the targets start automatically
Figure 62 Connected Targets tab
.
Installing and configuring the iSCSI driver for Red Hat 5
NOTE:
The iSCSI driver package is included but is not installed by default. Install the package
iscsi—initiator—utils during or after operating system installation.
To install and configure the iSCSI driver for Red Hat 5:
1. Use the iscsiadm command to control discovery and connectivity:
# iscsiadm –m discovery –t st –p 10.6.0.33:3260
2. Edit the initiator name:
# vi /etc/iscsi/initiatorname.iscsi
3. Start the iSCSI service:
# service iscsi start
78 MPX200 iSCSI configuration rules and guidelines
(Figure 62).