HP StorageWorks MPX200 User Manual page 172
Hp storageworks mpx200 multifunction router user guide (5697-0568, august 2010)
Hide thumbs
Also See for StorageWorks MPX200:
- User manual (258 pages) ,
- Solution manual (224 pages) ,
- Quickspecs (17 pages)
Table of Contents
Advertisement
WARNING:
The following command might cause a loss of connections to both GE ports.
Route
FC Port ID
-----
----------
1
FC1
2
FC2
Please select a FCIP route from the list above ('q' to quit): 1
Configuring FCIP Route:
-----------------------
FCIP Interfaces FC & GE (0=Enable, 1=Disable)
IP Address (IPv4 or IPv6; 0=IPv6 Link Local)
Subnet Mask
Gateway IP Address
Remote IP Address
MTU Size (0=Normal, 1=Jumbo, 2=Other)
TCP Window Size (0=8KB, 1=16KB, 2=32KB)
Window Scaling (0=Enable, 1=Disable)
Window Scaling Factor (Min=0, Max=9)
TCP Port No. (Min=1024, Max=65535)
GE Port Speed (0=Auto, 1=100Mb, 2=1Gb)
Bandwidth, Mbit/sec (Min=1, Max=1000)
VLAN (0=Enable, 1=Disable)
FCIP SW Compression(0=Enable,1=Disable,2=Auto)
Do you want to save/discard changes? (0=Save, 1=Discard)
All attribute values for FCIP Route 1 will now be saved.
MPX200 <2> (admin) #>
Example 3:
MPX200 <2> (admin) #> fciproute rm
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
WARNING:
The following command might cause a loss of connections to both GE ports.
Route
FC Port ID
-----
----------
1
FC1
2
FC2
Please select a FCIP route from the list above ('q' to quit): 1
FCIP Route 1 has been removed from the system.
MPX200 <2> (admin) #>
172
Command referencecommand reference
GE Port ID
----------
GE1
GE2
GE Port ID
----------
GE1
GE2
[Enabled
]
[44.44.1.124
]
[255.255.0.0
]
[0.0.0.0
]
[44.44.1.158
]
[Normal
]
[32768
]
[Enabled
]
[2
]
[3225
]
[Auto
]
[45
] 150
[Disabled
]
[Disabled
]
[Save
]
Advertisement
Table of Contents
Troubleshooting
