8.
Enter the command set mgmt to set the initial parameters.
Follow the on-screen prompts to configure the management port (or press Enter to accept the
default settings, as shown in
Figure 96 Setting IP addresses
.
The management port is now configured with the appropriate IP address and network parameters.
IMPORTANT:
If you are using Telnet to configure the MPX200, the Telnet session is terminated. To restart the Telnet
session, use the IP address you just assigned to the management port.
Step 6. Configure the MPX200 FCIP Route parameters
Install FCIP license
For each MPX200 blade, add the FCIP license as shown in
Figure 97 FCIP License Add
.
140
MPX200 FCIP
Figure
96):
Figure
97.