Adding Targets To The Qlogic Iscsi Initiator - HP MPX200 User Manual

Adding targets to the QLogic iSCSI initiator

To add HBA port targets:
1. Click the green plus sign
2. Enter the first iSCSI target port IP address.
Figure 84 HBA Port Target Configuration window
3. Repeat steps 1 and 2 for each MPX200 you want to add.
4. Click Next.
5. To activate the changes, enter the SMS password: config.
6. Select the Target Settings tab. Verify that the HBA state is Ready, Link Up and that each target
entry state is Session Active
Figure 85 Target Settings tab
(Figure 84 (page 93)).
(Figure 85 (page 93)).
Setting up the iSCSI initiator 93