HP StorageWorks MPX200 User Manual page 247

#%d: QLUpdatePort 0x%x: out
107078
of slots in host database
#%d: QLWriteFlashDword:
107984
Write fails at addr 0x%x
data 0x%x
#%d: QLGetVpDatabase:
108032
MBOX_CMD_GET_VP_DATABASE for
VP %d fatal error
#%d: QLGetVpDatabase:
108033
MBOX_CMD_GET_VP_DATABASE for
VP %d failed %x
#%d: QLVerifyMenloFw: EX-
108049
ECUTE_COMMAND_IOCB failed
MB0 %x MB1 %x
#%d: QLVerifyMenloFw: EX-
108050
ECUTE_COMMAND_IOCB fatal er-
ror
#%d: QLGetFwState: Get Firm-
108064
ware State failed 0-3 %x %x
%x %x
#%d: QLIoctlDisable: Reset
118882
adapter
#%d: QLIsrEventHandler: LIP
119088
occurred (%x): mailbox1 = %x
#%d: QLIsrEventHandler: LIP
119089
reset occurred (%x): mail-
box1 = %x
#%d: QLIsrEventHandler: Link
119090
up (%x) mailbox1 = %x
#%d: QLIsrEventHandler: Link
119092
mode up (%x): RunTimeMode=%x
#%d: QLIsrEventHandler: RSCN
119093
update (%x) rscnInfo: %x
#%d: QLIsrEventHandler: Port
119097
update (%x) mb1-3 %x %x %x
Driver was unable to re-establish
connection to the target within the
FC Error
timeout and retry counts, and is
therefore marking it offline.
FC controller failed a Flash write
FC Error
(address x data x).
FC controller failed the Get VP
FC Error Database command (for virtual
port %d).
FC controller failed the Get VP
FC Error Database command (for virtual
port %d) with status x.
FC controller reported failure status
FC Error for an Execute IOCB (input/output
control block) command.
FC controller reported a fatal error
FC Error while processing an Execute IOCB
command.
FC controller reported failure status
FC Error for a Get Firmware State com-
mand.
Request to reset the FC processor
FC Info (adapter) received from IOCTL in-
terface.
FC loop initialization process (LIP)
occurred. The LIP type is reported,
FC Info
as is the contents of the FC pro-
cessor's mailbox 1 register.
FC LIP reset occurred. The LIP reset
type is reported, as is the contents
FC Info
of the FC processor's mailbox 1
register.
FC link up occurred. Event status
is reported, as is the contents of
FC Info
the FC processor's mailbox 1 re-
gister.
FC link up occurred. Event status
FC Info is reported, as is the RunTimeMode
(0 = loop, 1 = point-to-point).
An RSCN was received. Event
FC Info status is reported, as is the RSCN
information.
FC port update. Event status is re-
ported, as is the contents of the FC
FC Info
processor's mailbox 1, 2, and 3
registers.
MPX200 Multifunction Router User Guide 247