3 Managing the MPX200 using HP
Command View EVA
This chapter provides instructions for setting up the MPX200 management port, Fibre Channel zoning,
HP Command View EVA discovery, setting up the iSCSI IP ports, and setting the date and time.
NOTE:
FCIP functionality is not completely configured using HP Command View EVA. For configuration
requirements, see
Setting up the MPX200 management port
Most management functions have been built into HP Command View EVA. In some cases, access to
the MPX200 CLI is required.
You connect to the CLI through one of the following:
•
RS-232 serial port (115200/8/n/1)
•
Telnet
•
Secure Shell (SSH)
By default, the management port obtains a Dynamic Host Configuration Protocol (DHCP) address. If
the management port cannot obtain a DHCP address, you must set a static IP address.
Fibre Channel zoning
Because the MPX200 can be a fabric-connected device, it is important to understand the zoning
requirements.
Open zoning
When using an open zone configuration, each FC port on each MPX200 must be connected to a
separate fabric (see
Chapter 6
on page 117.
Figure 18
on page 36).
MPX200 Multifunction Router User Guide
35