Step 5. Set The Mpx200 Management Port Parameters - HP StorageWorks MPX200 User Manual

Step 5. Set the MPX200 management port parameters

Use the following steps to set initial MPX200 configuration parameters or, if already configured, go
to step 6.
NOTE:
If you are using Telnet to configure the MPX200 for the first time, your workstation IP address must
be "10.0.0.x," where x is a number other than 1 and the subnet mask is 255.0.0.0.
1. Connect the MPX200 management port or serial console port to a workstation to set the initial
MPX200 configuration parameters. You can connect the MPX200 management port to an IP
switch, a hub, or directly to the workstation using an Ethernet crossover cable. If you are using
the MPX200 serial port, the settings are 115,200 baud, 8 bit, 1 stop bit, no parity, and no flow
control.
2. Attach both AC power cords to the power cooling modules (PCM) located at the front of the
MPX200, and a power distribution unit or AC power outlet. Verify that the MPX200 system power
LED is lit. The MPX200 runs a self-test and enters operating mode.
3. Verify that the heartbeat LED is blinking (once per second) and that the System fault LED does
not light.
NOTE:
For a description of the LED fault indicators, see the
diagnostics" on page 153.
4. Connect to the MPX200 from your management workstation as follows
a. Enter guest at the Login prompt.
b. Enter password at the Password prompt.
NOTE:
HP recommends that you change the MPX200 guest password after logging in.
5. Enter Blade n at the mpx200#> prompt, where n is the number of the blade in the chassis
being configured.
6. Enter admin start at the mpx200 <n> prompt, where n is the number of the blade currently
selected in the chassis.
7. Enter the default password config.
NOTE:
HP recommends that you change the MPX200 config password after logging in.
Figure 105 on page 153 shows the location of the ports and LEDs on the MPX200.
"MPX200 chassis
MPX200 Multifunction Router User Guide
(Figure 96).
139