Fciproute - HP StorageWorks MPX200 User Manual
Hp storageworks mpx200 multifunction router user guide (5697-0568, august 2010)
Hide thumbs
Also See for StorageWorks MPX200:
- User manual (258 pages) ,
- Solution manual (224 pages) ,
- Quickspecs (17 pages)
Table of Contents
Advertisement
Fciproute
Configures a new FCIP route or modifies or deletes an existing FCIP route. Each FCIP route requires
a dedicated FC and Gigabit Ethernet (GbE) port. Configuring an FCIP route and specifying an FC
and GE port pair take precedence over any previous configuration for the port pair (FC/GE).
Authority
Syntax
Keywords
Example 1:
MPX200 <2> (admin) #> fciproute add
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
WARNING:
The following command might cause a loss of connections to both GE ports.
Configuring FCIP Route:
-----------------------
FCIP Interfaces FC & GE (0=Enable, 1=Disable)
FC Port (1=FC1 )
GE Port (1=GE1 )
IP Address (IPv4 or IPv6; 0=IPv6 Link Local)
Subnet Mask
Gateway IP Address
Remote IP Address
MTU Size (0=Normal, 1=Jumbo, 2=Other)
TCP Window Size (0=8KB, 1=16KB, 2=32KB)
Window Scaling (0=Enable, 1=Disable)
Window Scaling Factor (Min=0, Max=9)
TCP Port No. (Min=1024, Max=65535)
GE Port Speed (0=Auto, 1=100Mb, 2=1Gb)
Bandwidth, Mbit/sec (Min=1, Max=1000)
VLAN (0=Enable, 1=Disable)
FCIP SW Compression(0=Enable,1=Disable,2=Auto)
All attribute values for FCIP Route 1 will now be saved.
MPX200 <2> (admin) #>
Example 2:
MPX200 <2> (admin) #> fciproute mod
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Admin session
fciproute [add | mod | rm]
Configure a new FCIP route
add
Modify an existing FCIP route
mod
Remove an existing FCIP route
rm
MPX200 Multifunction Router User Guide
[Enabled
]
[
] 1
[
] 1
[0.0.0.0
] 44.44.1.124
[0.0.0.0
] 255.255.0.0
[0.0.0.0
]
[0.0.0.0
] 44.44.1.158
[Normal
]
[32768
]
[Enabled
]
[7
] 2
[3225
]
[Auto
]
[1000
] 45
[Disabled
]
[Disabled
]
171
Advertisement
Table of Contents
Troubleshooting
