Managing The Mpx200 Using Hp Command View Eva; Setting Up The Mpx200 Management Port; Fibre Channel Zoning; Open Zoning - HP StorageWorks 6100 - Enterprise Virtual Array User Manual

3 Managing the MPX200 using HP
Command View EVA
This chapter provides instructions for setting up the MPX200 management port, Fibre Channel zoning,
HP Command View EVA discovery, setting up the iSCSI IP ports, and setting the date and time.
NOTE:
DMS and FCIP functionality are not completely configured using HP Command View EVA. See the
sections Appendix G

Setting up the MPX200 management port

Most management functions have been built into HP Command View EVA. In some cases, access to
the MPX200 CLI is required.
You connect to the CLI through one of the following:
• RS-232 serial port (115200/8/n/1)
• Telnet
• Secure Shell (SSH)
By default, the management port obtains a Dynamic Host Configuration Protocol (DHCP) address. If
the management port cannot obtain a DHCP address, you must set a static IP address.

Fibre Channel zoning

Because the MPX200 is a fabric-connected device only, it is important to understand the zoning
requirements.

Open zoning

When using an open zone configuration, each FC port on each MPX200 must be connected to a
separate fabric, as shown in .
on page 247 and Chapter 5 on page 101 for configuration requirements.
MPX200 Multifunction Router 33