Step 3. Rack-Mount The Mpx200; Step 4. Install The Sfps; Step 5. Set The Mpx200 Management Port Parameters - HP MPX200 User Manual

Step 3. Rack-mount the MPX200

See "MPX200 components" (page

Step 4. Install the SFPs

To install the SFPs:
NOTE: An SFP transceiver is required for each FC port that connects to an FC switch.
1. Align the SFP transceiver so that the key is oriented correctly to the port. Transceivers are
keyed so that they can be inserted only one way.
2. Insert the transceiver into the port.
3. Press gently until the transceiver snaps into place.

Step 5. Set the MPX200 management port parameters

Use the following steps to set initial MPX200 configuration parameters or, if already configured,
go to step 6.
NOTE: If you are using Telnet to configure the MPX200 for the first time, your workstation IP
address must be "10.0.0.x," where x is a number other than 1 and the subnet mask is 255.0.0.0.
1. Connect the MPX200 management port or serial console port to a workstation to set the initial
MPX200 configuration parameters. You can connect the MPX200 management port to an IP
switch, a hub, or directly to the workstation using an Ethernet crossover cable. If you are using
the MPX200 serial port, the settings are 1 15,200 baud, 8 bit, 1 stop bit, no parity, and no
flow control.
2. Attach both AC power cords to the PCM located at the front of the MPX200, and a power
distribution unit or AC power outlet. Verify that the MPX200 system power LED is lit. The
MPX200 runs a self-test and enters operating mode.
3. Verify that the heartbeat LED is blinking (once per second) and that the System fault LED does
not light.
LEDs on the MPX200.
NOTE:
(page 141).
4. Connect to the MPX200 from your management workstation as follows
129)).
a. Enter guest at the Login prompt.
b. Enter password at the Password prompt.
NOTE:
5. Enter Blade n at the mpx200#> prompt, where n is the number of the blade in the chassis
being configured.
6. Enter admin start at the mpx200 <n> prompt, where n is the number of the blade currently
selected in the chassis.
7. Enter the default password config.
NOTE:
128 MPX200 FCIP
26).
"MPX200 chassis diagnostic LEDs" (page 141)
For a description of the LED fault indicators, see the
HP recommends that you change the MPX200 guest password after logging in.
HP recommends that you change the MPX200 config password after logging in.
shows the location of the ports and
"MPX200 chassis diagnostics"
(Figure 108 (page