Furuno FELCOM 12 Operator's Manual page 167

Current State : Idle (pending!)
Current State : Testing
DCE Error : No response from DCE!!
Distress Message updated. Press any key.
Distress Alert Acknowledgment Received
FD not inserted in drive.
FD not inserted in drive. Press any key to escape.
File by that name already exists. OK to overwrite?
Formatting Completed.
Input Error : Message File
Internal GPS unit failure.
Invalid Frequency Code
Invalid NCS ID Code.
Loading
This message appears when a LES affir-
matively acknowledges your request for
PV testing.
You will see this display during PV test-
ing.
This message appears when you try to dis-
play the PV test results and there was no
response from the communication unit
because it is off or its interconnection cable
is disconnected or damaged.
This message appears after you have cor-
rectly updated the distress message.
This alert will appear when the LES trans-
mits the distress acknowledge signal to
your vessel.
You need to insert a floppy disk into the
drive.
This message appears if you attempt to
format a disk and there is no disk in the
drive.
This alert asks you if it is alright to write
over an existing file name.
This alert appears upon completion of
floppy disk formatting.
You have manually input an invalid file
name.
This message appears when the internal
installed GPS unit is not working or is
faulty. When the navigation port is not set
to "INT", this message does not appears.
.
This message appears when a wrong fre-
quency code is entered in the EGC Chan-
nel List or NCS Channel List.
This alert appears when a wrong NCS ID
code is entered.
Appears during loading of a file to a work-
ing area.
AP-13