Polling; Polling Command - Furuno FELCOM 12 Operator's Manual

Polling

5-6
27. Press [Esc] to register the above settings.
PIN Code
INT
Message Report Programming
Status
Station Name
Destination Type
Country/Ocean Code
Station ID
Modem Type
Subject
LES ID
Activation
Interval Time
Report Times
Start Time1
Start Time2
Start Time3
Start Time4
Report Contents
Figure 5-6 Message Report Screen
28. Select "Yes".
29. Press [Enter] to finish.
When the FELCOM 12 receives a polling command from your home
office, it automatically transmits data to your home office. The data
are position, speed, bearing and other data sent from a navigational
equipment or an interface unit.
A polling command from your home office can also activate data
report or message report if the corresponding setting is completed on
the FELCOM 12. If a polling command with a file name is received,
the FELCOM 12 transmits the file to your home office.

Polling command

This paragraph shows you how to make the polling command at your
home office.
There are two kinds of polling commands: one is sent on the MES
signalling channel and the other is sent on the MES message channel.
Polling command on MES signalling channel
Request a land station to make the polling command because the for-
mat vavies with land station.
Message Report
12345678
*********
ON
FRNINMBTSTSES
TELEX
583
343199710
303 (YAMAGUCHI)
Daily
01:00
24 (- - - : No Limit)
08:00
- - : - -
Entry
- - : - -
- - : - -
Yes
NAV+SEA INF
No