Table of Contents
Advertisement
XG Series User's Guide
3.1.1
Configure LAN Interface
The initial setting of the LAN interface is for only IPv6 link-local address.
To use the following functions, configure the LAN interface.
•
Telnet connection
•
SNMP manager connection
•
System log transmission
•
Time synchronization using an NTP/SNTP server
•
Configuration file upload/download
•
Firmware update
•
Collection of maintenance information
To configure the LAN interface, carry out the following procedure.
Login:admin
Password:
XG2600# configure
XG2600(config)# oob ip address A.B.C.D/M 3
XG2600(config)# lan 0 ip address A.B.C.D/M 3
XG2600(config)# lan 0 vlan 1
XG2600(config)# proxydns domain 0 any * any
static A.B.C.D
XG2600(config)# commit
XG2600(config)# save
XG2600(config)# exit
3.1.2
Telnet Connection via the LAN Interface (Optional)
The "Telnet server function" is initially enabled.
The telnet session timeout period is initially 5 minutes.
To change the telnet session timeout period, carry out the following procedure in "admin" Operation mode.
XG2600# configure
XG2600(config)# telnetinfo autologout 30m
XG2600(config)# commit
XG2600(config)# save
XG2600(config)# exit
Command
Command
Login to the device from the serial terminal. The user name is
"admin". Type the password for uset "admin".
Switch to Configuration mode.
Set the IP address, subnet, and default gateway of the LAN interface
for management port. (XG2600 only)
Set the IP address, subnet, and default gateway of the LAN interface
for VLAN ID 1.
(Optional)
Set up DNS servers.
Apply the configuration.
Save the configuration.
Switch to Operation mode.
Switch to Configuration mode.
Set the Telnet session timeout period (30 minutes).
If the Telnet session timeout period expires the telne connection is
terminated.
Apply the configuration.
Save the configuration.
Switch to Operation mode.
57
Chapter 3 Installation
Task
Task
Workflow for Initial Setup of the Device
Advertisement
Table of Contents
