Table of Contents
Advertisement
XG Series User's Guide
4.
Log in with the account name "ftp-admin".
Log in to the device using FTP command.
Login name: ftp-admin
Password: The password is the one made with the "password set" command.
If no password has been set, there is no need to enter one.
Confirm the password with the system administrator.
D:\FIRM>ftp 192.168.1.1
Connected to 192.168.1.1
220 XG2600 V01.00 FTP server ready.
User (192.168.1.1:(none)): ftp-admin
331 Password required for ftp-admin.
Password:
230 User ftp-admin logged in.
ftp>
5.
Transfer the firmware to the device.
Transfer the firmware to the device in "binary" mode.
Input "put [the file name of the put personal computer (XG2600SOFT.ftp)] [the file name of the device (firmware)]" in the
"put" command.
ftp>binary
200 Type set to I.
ftp>put XG2600SOFT.ftp firmware
local: XG2600SOFT.ftp remote: firmware
200 PORT command successful.
150 Opening BINARY mode data connection for `firmware´.
226- Transfer complete.
update : Transfer file check now!
update : Transfer file check ok.
When forwarding firmware to this product, the destination file name must be input as "firmware". Anything other than
Note
"firmware" cannot be input.
6.
Check that the firmware is completely transferred.
When "Write complete" message is displayed, it indicates that the process is terminated successfully.
226 Write complete.
ftp>
7.
Exit the ftp mode.
ftp> quit
221 Goodbye.
D:\FIRM>
8.
Remove the device from the chassis, wait about 10 seconds, and reinsert the device to the chassis.
The power is turned on again, and the firmware is enabled.
: Connect the device
(Specify IP address of the device)
: Type login name
: Type password
: Set "binary" mode
: Write the "XG2600SOFT.ftp" file as a firmware
.
.
.
.
: Exit "ftp" command
569
Chapter 6 Managing the Device
Updating Firmware
Advertisement
Table of Contents
