Fujitsu XG Series User Manual page 562

XG Series User's Guide
• The following error message may be displayed while using ftp commands:
502 PASV command not implemented.
Passive mode regused.
If this error message is displayed, perform the following operation and retry the failed operation:
ftp> passive : Change the passive mode.
Passive mode off.
Saving configuration information using the FTP server function
The following explains how to save configuration information using ftp commands on a PC.
Precautions
Be sure to observe the following precautions while performing maintenance operations:
• Do not cut power to the device.
• Ensure that no data communication is taking place on the device.
• Perform these operations only when no configuration is taking place on the console.
Example of using an ftp command
The following example saves configuration information 1 to the config1-1 file on the PC.
C:\>cd Directory in which to store configuration information
C:\tmp>ftp 192.168.1.1
Connected to 192.168.1.1.
220 XG2600 V01.00 FTP server (config1) ready.
Name(192.168.1.1:root): ftp-admin
331 Password required for ftp-admin.
Password:
230 User ftp-admin logged in.
ftp>bin
200 Type set to I.
fftp>get config1 config1-1
local: config1 remote: config1-1
200 PORT command successful.
150 Opening BINARY mode data connection for 'config1'(2753 bytes)
•
226- Transfer complete.
2857 bytes received in 1.10 seconds (2.44 Kbytes/s)
ftp>bye
221 Goodbye.
C:\tmp>
Get configuration information
with an ftp command
FTP client
: Connect to the device.
: Enter the user name.
: Enter the password.
: Enter binary mode.
: Save configuration information 1 (config1) to the config1-1 file.
: Finish
562
Chapter 6 Managing the Device
IP address
192.168.1.1
Saving/Restoring Configuration Information