Switch Interface Side - Fujitsu XG2600 Hardware Manual

XG2600 Hardware Guide
1.1.4

Switch Interface Side

PSU Slots for
Rear-Access Installation
PSU1
Power Supply Unit
Power Inlet
• PSU Slots for Rear-Access Installation
• Power Inlet
• Power Supply Unit
• SFP+ Slots
• Reset Switch
• USB Port
• Serial Port (Console Connection)
Caution
Serial Port is only used for connecting the switch with RS-232C interface of the console. Do not
connect other interfaces such as LAN/ISDN which cause an error.
Reference User's Guide
• Management Port
Port1
Port2
PSU2
Power Supply Unit
PSUs are plugged in the slots when the switch is used in Rear-Access configuration.
Plug the attached Power Cable in the package.
This switch is installed with two PSUs.
Plug SFP+ modules for connecting Ethernet based networking equipment (10GBASE-
SR/10GBASE-LR).
Port number is assigned from the upper side of the leftmost port to the right. For
example, Port 1 is the upper side of the leftmost port, and Port 26 is the lower side of the
right most port.
Push to reboot.
Connect USB memory for backup-copying and restoring configuration files and
firmware.
The Serial Port is used to connect the switch with the console (PC) for setting and
command line interface via the attached Console Cable (RJ45 to Serial Adapter) and
RS232C crossover cable (D-SUB9) .
"1.1.5 Console Port Specifications" (pg.28)
This is used to connect Ethernet based (10/100BASE-TX) networking equipment. Use
Category-5 LAN cables.
20
Reset Switch
SFP+ Slots
Port25
Port26
Management Port
Items in the Package / Names and Functions
Chapter 1 Getting Started
Serial Port
USB Port