Executable Commands - Fujitsu XG Series User Manual

XG Series User's Guide

2.1.2.2 Executable commands

Command execution is restricted according to the following conditions:
• Command type
• Privilege class
• Use mode
" Privilege classes (admin class and user class)"
Reference
" Use modes (operation mode and configuration mode)" (pg.41)
Command type (operation commands and configuration commands)
Two command types are available; operation commands and configuration commands.
Since the use mode after logging into the system is operation mode, you can only run operation commands.
By running a configure command, the use mode changes to configuration mode and you will be able to run configuration
commands as well as operation commands.
However, since you cannot run a configure command in user class, run an admin command to change to admin class before
running the configure command.
The following table lists command types and functions.
Command type
Operation command
Configuration command
The following table lists commands and operations.
Command
Configuration command
commit command
save command
Run reset command or reconnect
power
show candidate-config command
show running-config command
show startup-config command
delete command
Precautions
If you run a reset command or reconnect power without first running a save command, the running configuration and
candidate configuration will return to the state they were in before running a configuration command.
Command function
Display and manipulate device status, operation status, and
network status, display or delete stored information, etc.
Operating information settings and network configuration,
etc.
Sets to candidate configuration (candidate-config).
These are basically not reflected in running operations; however, as in password
information configuration, there are commands to reflect settings immediately.
The candidate configuration is reflected in the running configuration (running-
config) and active operations change.
"5.48 Effect by "commit" Command Execution" (pg.543)
Reference
Reference
Saves candidate configuration to startup configuration (startup-config).
Applies candidate configuration to the running configuration.
Displays candidate configuration settings.
Displays active configuration settings.
Displays startup configuration settings.
Deletes configuration settings.
42
(pg.41),
Operation
Chapter 2 Using the CLI
Overview of the CLI