Vlan Ip6Filter - Fujitsu XG Series User Manual

XG Series User's Guide
5.3.3.3

vlan ip6filter

Function
Available Model
Syntax
Options
Use Mode
Explanation
Caution
Set VLAN IPv6 filter
XG0224 / XG0448
vlan <vid> ip6filter <count> <action> <acl>
<vid>
• VLAN ID
Specify the VLAN ID with a decimal value from 1 to 4094.
<count>
• Priority
Set the filtering priority with a decimal value
A smaller value has a higher priority.
Range
0 to 511 XG0224 / XG0448
<action>
• pass
Pass the packets which match "acl ip6", "acl icmp", "acl tcp" and "acl udp"
• reject
Discard the packets which match "acl ip6", "acl icmp", "acl tcp" and "acl udp"
<acl>
• ACL definition number
Specify the ACL definition number which is used for the filter
Configuration mode (admin class)
Set IPv6 filtering per VLAN
Action specified in <action> works packets which match access control list which is
defined in "acl ip6", "acl icmp", "acl tcp" and "acl udp"
Note 1.
If none of "acl ip6" definition exist on the access control list which has been specified by
<acl> or if the access control list specified by <acl> does not exist, the packets are not
filtered.
Note 2.
The packet filtering default value is "pass".
No packets are filtered if only "pass" is set in <action>.
Note 3.
This command is unavailable if the allowable upper limit for the device is exceeded.
The allowable upper limits are as follows.
• Upper limit based on "commands"
128 commands for the entire device.
Up to 128 commands can be set for the entire device, including the
"lan ip6 filter" commands.
The priority for each command is as follows.
170
Chapter 5 Command Reference
Model
"vlan ip6filter"
VLAN Information Settings
and