Actions When Firmware Update Failes (Backup Firm Function); Preparing The Device - Fujitsu XG Series User Manual

XG Series User's Guide
6.4 Actions When Firmware Update
Failes (Backup Firm Function)
If the firmware update fails due to power failure or some other reason and you cannot start this device, you can restore the
device to its normal condition by starting the backup firmware and transferring the firmware with an FTP client on the
network or by a compact flash card.
6.4.1

Preparing the Device

Precautions
When the device boots up Backup Firm, the IP address of Management-port (XG2600) or LAN port (XG0224 /
XG0448) is set 192.168.1.1.
A problem has come up, so please connect only this device and a PC.
1. Make sure that the power of this device is turned off.
2. Connect this device and a PC via LAN.
• XG2600
Directly connect a cable to Management Port (10/100BASE-TX port) of this device and the PC instead of using a HUB
in between.
Management-port of XG2600 (10/100BASE-TX) is MDI fixed.
Note
• XG0224 / XG0448
Directly connect a cable to 10/100/1000BASE-T ports of this device and the PC instead of using a HUB in between.
[XG0224]
As this device supports AutoMDI/MDI-X function, you can connect a cable to 10/100/1000BASE-T ports without being
Note
conscious of the PC and HUB.
[XG0448]
574

Actions When Firmware Update Failes (Backup Firm Function)

Chapter 6 Managing the Device