Connecting To The Network; Installing Module Into Matrix N3, N1, Or N5 Chassis (Matrix N3 Shown) - Enterasys Gold Distributed Forwarding Engine 4H4202-72 Hardware Installation Manual

Connecting to the Network

Figure 3-3
1 Card guides
2 Slot 1 (Top slot is slot 3.)
3 Module card
4 Metal back panel
Connecting to the Network
For connecting unshielded twisted pair (UTP) segments from the network or other
devices, refer to
• Connecting UTP Cables to 4H4282‐49 or 4H4202‐72 (page 3‐11)
• Connecting UTP Cables to 4H4283‐49 or 4H4203‐72 (page 3‐15)
For fiber‐optic connections, refer to
• Connecting Fiber‐Optic Cables to 4H4284‐49 (page 3‐18)
3-10 Installation

Installing Module into Matrix N3, N1, or N5 Chassis (Matrix N3 shown)

➆
➄
Note: If the DFE-Gold module is being installed in a network using Link Aggregation, there
are rules concerning the network cable and port configurations that must be followed for
Link Aggregation to operate properly. Before connecting the cables, refer to the Enterasys
Matrix DFE-Gold Series Configuration Guide for the configuration information. For details
on how to obtain manuals, refer to "
➃
➂
➀
5 Upper locking tab (shown in closed position)
6 Lower locking tab (shown in closed position)
7 FTM2 backplane and power connectors
"Related Documents" on page xvi.
➁
➅