Connecting to the Network
Installing the Power Cord Retention Clip Assembly
The SSA switch comes with two optional power cord retention clip assemblies. Power cord
retention clips provide added security against the inadvertent removal of the power cord from the
the power supply AC receptacle.
To install the power cord retention clip assembly:
1.
Holding the strap piece with the rough side facing away from the power supply, shown by
callout 2 of
power cord receptacle, shown by callout 1.
2.
Slide the power cable clamp, shown by callout 3, onto the strap piece with the tab on the
clamp piece facing out.
3.
Insert the power cord in the open clamp.
4.
Close the clamp piece.
To open the clamp piece, push down the clamp release tab, shown by callout 4.
Figure 2-11
1
Retention clip receptacle
2
Retention clip strap piece, smooth side facing
power supply
Connecting to the Network
This section provides the procedures for connecting Category 6 unshielded twisted pair (UTP)
segments or SFP or SFP+ pluggable transceivers from the network or other devices to the SSA
switch.
2-14 Installation
Figure 2-11
on page 2-14, insert the strap piece into the hole to the right of the
Installing the Power Cord Clip Assembly in the Power Supply
Note: If the SSA switch is being installed in a network using Link Aggregation, there are rules
concerning the network cable and port configurations that must be followed for Link Aggregation to
operate properly. Before connecting the cables, refer to the Enterasys S-Series Configuration
Guide for configuration information. For details on how to obtain manuals, refer to
Documents"
on page xvi.
3
Power cable clamp
4
Clamp release tab
"Related