First-Time Log-In Using a Console Port Connection
Note: This procedure applies only to initial log-in, and to logging in to a device not yet
configured with administratively-supplied user and password settings.
By default, the Matrix DFE Series device is configured with three user login accounts: ro
for Read-Only access; rw for Read-Write access; and admin for super-user access to all
modifiable parameters. The default password is set to blank (carriage return). For
information on changing these default passwords, refer to Chapter 3 in the Enterasys
Matrix DFE-Gold Series Configuration Guide.
Start the Command Line Interface (CLI) from the module's local console port as follows:
1.
Connect a terminal to the local console port as described in "Connecting to COM Port
for Local Management" on page
2.
At the login prompt, enter one of the following default user names:
–
ro for Read‐Only access,
–
rw for Read‐Write access, or
–
admin for Super User access. (This access level allows Read‐Write access to all
modifiable parameters, including user accounts.)
3.
Press ENTER.
4.
The Password prompt displays. Leave this string blank and press ENTER. The
module information and Matrix prompt displays as shown in Figure
The DFE‐Gold module is now ready to be configured. For information about setting the IP
address and configuring Telnet settings for remote access to DFE management, refer to
Chapter 3 in the Enterasys Matrix DFE‐Gold Series Configuration Guide. The CLI commands
enable you to initially set up and perform more involved management configurations.
The Enterasys Matrix DFE‐Gold Series Configuration Guide is available online at:
http://www.enterasys.com/support/manuals
If you require assistance, contact Enterasys Networks using one of the methods described
in "Getting Help" on page xviii.
3‐20. The startup screen, Figure
Matrix DFE-Gold Series Modules Hardware Installation Guide 3-27
Completing the Installation
3‐15, displays.
3‐15.
Need help?
Do you have a question about the Enterasys Gold Distributed Forwarding Engine 4H4202-72 and is the answer not in the manual?
Questions and answers