Dimm Replacement Procedure (All Dfe Modules; Removing The Dimm; Removing The Existing Dimm - Enterasys Gold Distributed Forwarding Engine 4H4202-72 Hardware Installation Manual

Memory Locations and Replacement Procedures

DIMM Replacement Procedure (All DFE Modules)

In the event that the DIMM needs to be replaced, the following sections explain how to
remove and install the DIMM. If you have questions concerning the replacement of the
DIMM, refer to "Getting Help" on page xviii for details on how to contact
Enterasys Networks.

Removing the DIMM

To remove the existing DIMM, proceed as follows:
1. Locate the DIMM connector on the main PC board. Refer back to Figure
DIMM location on either the 4H4282‐49 or 4H4283‐49. Refer back to Figure
location on the 4H4203‐72.
2. Push the connector arms away from the DIMM, as shown in Figure
simultaneously lift the DIMM enough to release it from the connector fingers.
Figure B-13
1 Connector arms
3. Rotate the DIMM upwards, then remove it from the connector fingers.
B-12 Mode Switch Bank Settings and Optional Installations
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.

Removing the Existing DIMM

À
Â
2 DIMM
B‐13, and
Á
À
3 Connector fingers
B‐5 for the
B‐6 for the