Table of Contents
Advertisement
To install the power cord retention clip assembly:
1.
Holding the strap piece with the rough side facing away from the power supply, shown by
callout 2 of
power cord receptacle, shown by callout 1.
2.
Slide the power cable clamp, shown by callout 3, onto the strap piece with the tab on the
clamp piece facing out.
3.
Insert the power cord in the open clamp.
4.
Close the clamp piece.
To open the clamp piece, push down the clamp release tab, shown by callout 4.
Figure 2-11
1
Retention clip receptacle
2
Retention clip strap piece, smooth side facing
power supply
Connecting to the Network
This section provides the procedures for connecting Category 6 unshielded twisted pair (UTP)
segments or SFP+ or QSFP+ pluggable transceivers from the network or other devices to the
7100G-Series switch.
Connecting Category 5E Ethernet Cables to the BASE-T Ports
The fixed BASE-T (RJ45) front panel connections of the 71G21K2L2-48P and 71G21K2L2-24P24 are
10/100/1000Mb PoE (.at+.af capable) ports. They have internal crossovers and support
Figure 2-11
on page 2-15, insert the strap piece into the hole to the right of the
Installing the Power Cord Clip Assembly in the Power Supply
Note: If the 7100G-Series switch is being installed in a network using Link Aggregation, there are
rules concerning the network cable and port configurations that must be followed for Link
Aggregation to operate properly. Before connecting the cables, refer to the Enterasys 7100-Series
Configuration Guide for configuration information. For details on how to obtain manuals, refer to
"Related Documents"
on page xvi.
3
Power cable clamp
4
Clamp release tab
Enterasys 7100G-Series Hardware Installation Guide 2-15
Connecting to the Network
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
