Table of Contents
Advertisement
Installing an Optional Mini-GBIC
Installation
To install a Mini‐GBIC with an MT‐RJ connection, refer to Figure
connection, refer to Figure 3‐4. For an RJ45 connection, refer to Figure
as described below.
1.
Hold the Mini‐GBIC with its top side facing up and its 7‐pin edge connector facing the
port slot.
2.
Carefully align the Mini‐GBIC with the port slot.
3.
Push the Mini‐GBIC into the port slot until the Mini‐GBIC "clicks" and locks into
place.
Figure 3-3
1 Mini-GBIC (MGBIC-MT01)
2 Mini-GBIC
3 7-Pin edge connector (insertion side)
3-6 Installation
Note: If the Mini-GBIC is one with an RJ45 connector such as an MGBIC-02
the installation procedure is the same as described below. However, the Mini-GBIC has a
wire handle to release it.
Mini-GBIC with MT-RJ Connector
Ä
Å
top side
,
Á
Ã
À
3‐3. For an LC
3‐5. Then proceed
4 Port slot
5 Mini-GBIC
protective dust cover
,
6 Release tab
(Figure
3-5),
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Enterasys Gold Distributed Forwarding Engine 4G4282-49 and is the answer not in the manual?
Questions and answers