Considerations Prior To Installation - Enterasys A4H124-24FX Hardware Installation Manual

Read the Release Notes for the latest A4 firmware release for your A4 switch to check for any exceptions to
the supported features and operation documented in this guide.
This chapter provides instructions to install the A4. Unless otherwise noted, the instructions apply
to all A4 models. Follow the order of the sections listed below to correctly install the switch.
For information about...

Considerations Prior to Installation

Required Tools
Unpacking the Switch
Installing the Switch on a Flat Surface
Connecting Stacking Cables
Configuring Switches in a Stack
Connecting AC Power
Installing and Connecting a Redundant Power System
Connecting to the Console Port for Local Management
Connecting to the Network
Completing the Installation
Considerations Prior to Installation
When installing the switch, note the following:
• Before starting the installation procedure, notify the network administrator of the installation.
• Follow the installation procedures in the order as presented in this guide.
• Do not connect the switch to the network until you have established the correct IP address.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes
Personal vorgenommen werden.
Important Notice
Enterasys A4 Fast Ethernet Switch Hardware Installation Guide 2-1
2
Installation
Refer to page...
2-1
2-2
2-2
2-2
2-5
2-7
2-9
2-10
2-18
2-20
2-27