Connecting A Twisted Pair Segment To The Dfe-Gold Module - Enterasys Gold Distributed Forwarding Engine 4G4282-49 Hardware Installation Manual

Enterasys networks switch hardware installation guide

Table of Contents

Figure 3‐10 for four‐wire RJ45 connections. Refer to Figure 3‐11 and Figure

for eight‐wire RJ45 connections.

Ensure that the twisted pair connection meets the dB loss and cable specifications

outlined in the Cabling Guide. Refer to "Related Documents" on page xiv for

information on obtaining this document. If a link is still not established, contact

Enterasys Networks. Refer to "Getting Help" on page 1‐8 for details.

Repeat steps 1 through 3 above, until all connections have been made.

Figure 3-8

Connecting a Twisted Pair Segment to the DFE-Gold Module

1 RJ45 connector

2 RJ45 port connector (port 1)

3 Transmit status (TX) LED

4 Receive status (RX) LED

Connecting to the Network

5 GROUP SELECT button

Matrix DFE-Gold Series Installation Guide 3-17

3‐12

Table of Contents

Do you have a question about the Enterasys Gold Distributed Forwarding Engine 4G4282-49 and is the answer not in the manual?