Connecting To A Modem; Connecting A Vt Series Terminal - Enterasys Gold Distributed Forwarding Engine 4G4282-49 Hardware Installation Manual

Connecting to COM Port for Local Management
When these parameters are set, the Local Management password screen will display.
Refer to the Matrix DFE‐Gold Series Configuration Guide for further information.
Figure 3-16
1 UTP straight-through cable with RJ45 connectors
2 RJ45 COM port

Connecting to a Modem

To connect a modem to an Enterasys Networks DFE‐Gold module COM port
(Figure
male adapter, and proceed as follows:
1. Connect the RJ45 connector at one end of the UTP straight‐through cable to the COM
port of the DFE‐Gold module.
2. Plug the RJ45 connector at the other end of the UTP straight‐through cable into the
RJ45‐to‐DB25 modem adapter.
3. Connect the RJ45‐to‐DB25 adapter to the communications port on the modem.
4. Turn on the modem.
3-26 Installation

Connecting a VT Series Terminal

Ã
3‐17), use a UTP straight‐through cable with RJ45 connectors and an RJ45‐to‐DB25
 3 RJ45-to-DB25 VT adapter
4 VT series terminal
Á