Figure 3-7
1 Card guides
2 Slot 1 (Top slot is slot 3.)
3 Module card
4 Metal back panel
Connecting to the Network
This section provides the procedures for connecting unshielded twisted pair (UTP)
segments from the network or other devices to the 4G4282‐49 and 4G4202‐72
("Connecting UTP Cables" on page 3‐16). For connections to Mini‐GBIC ports on the
7G‐6MGBIC or 7G‐6MGBIC‐A, refer to "Connecting Fiber‐Optic Cables to Mini‐GBICs"
on page 3‐20.
Installing Module into N1, N3, or N5 Chassis (only N3 shown)
Æ
Ä
Note: If the DFE-Gold module is being installed in a network using Link Aggregation, there
are rules concerning network cables and port configurations that must be followed for Link
Aggregation to operate properly. Before connecting the cables, refer to the
Matrix DFE-Gold Series Configuration Guide for the configuration information. For details
on how to obtain manuals, refer to the
Å
5 Upper locking tab (shown in closed position)
6 Lower locking tab (shown in closed position)
7 FTM2 backplane connectors
"Related
Documents" on page xiv
Matrix DFE-Gold Series Installation Guide 3-15
Connecting to the Network
Á
Â
Ã
À
.