Removing The Y-Ca Motor; Removing The Y-Cutter Arm - Brother LX-300 Service Manual

3.7.2

Removing the Y-CA Motor

1. Remove the Y-CA motor screws and remove the Y-CA motor.
3.7.3

Removing the Y-cutter Arm

1. Remove the retaining ring from the Y-cutter arm shaft, pull out the Y-cutter arm shaft,
and remove the Y-cutter arm.
2. Remove the Y-CA arm screw, then remove the Y-CA arm.
Retaining rings
Y-CA motor screw
Fig. 3.7-2 Removing the Y-CA Motor
Y-cutter arm
Fig. 3.7-3 Removing the Y-cutter Arm
3-20
Y-CA motor
Y sensor
carriage arm
screw
Y-CA arm
Y-cutter arm shaft