Brother LX-300 Service Manual page 98

2. Put the Body cover on the Bottom cover, slightly in front of its correct position.
Insert the Paper tray B into the paper feed slot in the Body cover.
3. Insert the Y-cutter guide R lug into the slots in the Dial SW assy in front of the Body
cover.
Lug
4. Push the Body cover down while holding down the Y-diversion lever.
∗
Take care not to apply too much force. Not much force is required if Step 3 is
conducted correctly.
5. Check that the two hooks at the front of the Body cover are engaged. Repeat from
step 2 if the hooks are not engaged.
6. Check that the two hooks at the sides of the Body cover are engaged. Press down
on Part A if the hooks are not engaged.
7. Push down the rear of the Body cover to engage the six hooks.
Side hooks
Body cover
Part A
Front hooks
Y-cutter guide R
Fig. 4.17-12 Installing the Body Cover 2
Part A
Rear hooks
Y-diversion lever
Fig. 4.17-13 Installing the Body Cover 3
4-38
Paper tray B
Body cover
Slot
Dial switch assy
Bottom cover B