Chassis Assy; Removing The Harness Connectors - Brother LX-300 Service Manual

3.4 Chassis Assy

3.4.1

Removing the Harness Connectors

1. Remove 11 harness connectors from the Main PCB. Do not remove the power
harness assy (red/black CN13).
2. Disconnect the harnesses from the eight hooks on the Bottom cover B.
3. Peel off the tape that holds the harnesses inside the right of Bottom cover B, then
remove the harnesses from the Bottom cover B.
Power harness assy
Fig. 3.4-1 Removing the Harness Connectors 1
Fig. 3.4-2 Removing the Harness Connectors 2
3-12