Adjusting Perpendicularity Of Chassis And Document - Brother LX-300 Service Manual

6.3.3

Adjusting Perpendicularity of Chassis and Document

1. Loosen the four screws under the Bottom cover, as shown in the diagram below.
2. Insert the L-shaped jig for perpendicularity adjustment between the square holes in
the Chassis and bosses protruding from the Bottom cover. Push the Chassis into
position in the direction of the arrow shown in the diagram.
3. Taking care not to displace the Chassis, tighten the screws A and A'. Remove the
jig and tighten the remaining two screws.
Paper Feed Roller
Square Hole
Boss
Fig. 6.3-3
Boss Screws
Jig
Square Hole
Adjusting Perpendicularity of Chassis and Document
X Cutter
6-20
CL2000012
Screws