Installing Spm - Lucent Technologies MERLIN LEGEND Release 5.0 Pocket Reference

Installing SPM

Follow these steps to install System Programming and Maintenance (SPM)
onto the hard drive of a computer:
1. Insert the SPM diskette into the computer.
2. At the C: prompt, type MKDIR SPM and press ENTER.
3. Type cd\spm and press ENTER.
4. Type a:install and press ENTER to install the program from the
diskette.
5. After the installation is complete, type spm and press ENTER to display
the SPM Welcome screen.
Accessing SPM
Direct Local Connection
Follow these steps to access SPM when you are directly connected to the
system via the administration jack on the processor module:
1. Set up the physical connection between your laptop or PC and the
control unit.
2. Type spm and press ENTER to display the SPM Welcome screen.
3. Press any key to display the SPM Main Menu.
Local Modem Connection
Follow these steps to access SPM when you are connected on-site via a
modem:
1. Set up the physical connections between the PC and a 012 module on
the control unit.
2. Type spm and press ENTER to display the SPM Welcome screen.
3. Press ENTER to display a blank screen on which you can enter modem
commands. (You may have to press ENTER several times.)
4. Dial ATDT *10.
5. Type the SPM password to display the SPM Main Menu.
Remote Modem Connection
Follow these steps to access SPM when you connected off-site via a
modem:
1. Type spm and press ENTER to display the SPM Welcome screen.
2. Press ENTER to display a blank screen on which you can enter modem
commands. (You may have to press ENTER several times.)
3. If your system has activated the Remote Access feature, type the
following:
a. ATDT
b. Remote access telephone number
c. Barrier code (if existing) preceded by a "W."
d. W*10
Technician's Addendum
141