Release 3.0 Enhancements - Lucent Technologies MERLIN LEGEND Release 5.0 Pocket Reference

Release 3.0 Enhancements

Release 3.0 includes all Release 2.1 functionality plus the enhancements
listed below.
Equipment
New hardware includes a variety of components. Additional details are
included elsewhere in this book.
CPU modifications include:
A processor running at 16 MHz with a 32-bit wide data bus
1.5 Mbytes of non-volatile (battery-backed) RAM
4.0 Mbytes of Flash ROM
PCMCIA memory card interface
A full-duplex 1200/2400 bps modem
Error/Status code display for maintenance support
An 800 GS/LS-ID line/trunk module delivers the calling party's telephone
number to the customer premises (MLX display telephones only) if the
service is subscribed to by the customer and if it is supported by the
caller's local telephone company.
Support for:
MDC 9000 (6-line, cordless)
MDW 9000 (6-line, cordless, wireless)
8101 (single-line telephone, desk or wall-mount, data/fax jack, selectable
positive disconnect)
2500YMGL and 2500 MMGL (single-line desk telephones, selectable
positive disconnect)
Picasso ™ Still-Image telephone (for interactive display of still images)
Videophone 2500 single-line phone with interactive video display
Pre-fabricated and pre-drilled backboard
Installation, Upgrade Administration, and Maintenance
These are the new MERLIN LEGEND Communications System capabilities:
SPM (Release 3.18) conversion of translations from Release 1.0, 1.1,
2.0, and 2.1 to 3.0
Remote operation at 1200/2400bps
Advice and feedback administration screens for new Release 3.0
functionality
PCMCIA Memory Card Interface (a Release 3.0 processor board
required) allowing:
System software installation
System software upgrade
800 GS/LS-ID port module firmware upgrade
Integrated backup and restore of translations
Automatic and manual options for backup and restore are available
on the system. Automatic backup can be scheduled weekly or
daily to fit the customer's needs.
Inter-digit dialing timer values are administratable
Inspection of Lines/Trunks displays only those lines and trunks
configured on system rather than all 80 facilities
Stations and facilities in Maintenance Busy (both manual and automatic)
can be identified by the maintenance monitor
User Features
7