Foot Control; Operating Instructions; Power Switch - Bernina Artista 200 Manual

Setting up the Sewing Computer
Power Cable
C
Power Cable
plug A into sewing computer
plug B into electrical outlet
Foot Control Cable
plug C into sewing computer
(look for symbol)
Important! (USA/Canada only)
Use only foot controller type LV1
for sewing computer model
artista 200.

Power Switch

!
Refer to the safety
instructions!
FHS (Free Hand System) Presser Foot Lifter

Foot Control

A
B
Sewing Speed
control the sewing speed by
•
depressing the foot control
raise or lower the needle by
•
tapping on the foot control
with your heel

Operating Instructions

Important! (USA/Canada only)
This sewing computer has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug is intended
to fit only one way into a polarized outlet. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do not modify the
plug in any way.
Power Switch
The power switch is on the handwheel side of the sewing computer.
1
the sewing computer is switched on («1»)
0 the sewing computer is switched off («0»)
The sewing light is switched on and off with the power switch.
Raising and Lowering the Presser
Foot
the presser foot lifter raises and
lowers the presser foot
push to the right with your knee
the presser foot is raised and the
feed dog is lowered simultaneously
the feed dog comes up
automatically as soon as the first
stitch is sewn
030794.71.04_0401_a200_EN
B
A
Cable Tidy
wind the cable around the spool
insert the plug into A
When Sewing
unwind the cable to the desired
length and slip into B or C
Attaching the Free Hand System
insert the free hand system into the
opening in the base plate
you should be able to operate the
FHS in your normal sitting position
with your knee
Note:
Your dealer can adjust the
position of the FHS if necessary.
The Sewing Computer – Operating Instructions
C
11