Preparing the Embroidery Computer for Embroidery
Embroidery Presser Foot
No. 15
attach the Embroidery presser
foot No. 15
raise the presser foot so that
the embroidery hoop can be
attached
Straight Stitch Plate (optional accessory)
the straight stitch plate has a small needle hole. The needle insertion points (upper and lower thread
•
stitching) are limited, which produces a better embroidery result
remove the standard stitch plate and replace it with the straight stitch plate
Threading Upper and Bobbin Thread
TIP
Spool pin
When using metallic or specialty threads, using the
vertical spool pin and the supplementary thread guide
(special accessory) may also help avoid problems.
Needles for Embroidery
raise the needle so that the
embroidery hoop can be
attached
for more information on Needles see pages 17-19
•
General Operating
for more information on Stitch Plates see page 17
•
Threading the Upper Thread
attach foam pad and place the upper thread spool
when using Rayon or slippery embroidery threads, slip
the net over the upper thread spool
this prevents the upper thread from slipping and gives
•
an even thread feed
Threading the Bobbin Thread
for embroidery, thread the bobbin
thread through the pigtail tensioner
of the embroidery bobbin case
Note:
Lower thread indicator sensor will only work when the bobbin
cover is closed, after inserting the embroidery bobbin case.
(Sensor has to be activated in the Setup Program.)
Note:
While embroidering the bobbin can also be
wound, just like in sewing (see page 13).
The Embroidery Computer – General Operating Instructions
030794.71.04_0401_a200_EN
Lower the Feed Dog
press the button on the right
side of the sewing computer to
lower the feed dog
•••••••••••
Instructions
•••••••••••••
193